Skip to content

Equipment & Instruments

No filters applied

Air scrubber and restoration equipment guide

This page covers restoration and abatement equipment for water damage, mold and asbestos jobs. That means HEPA air scrubbers, commercial dehumidifiers, air movers, water extractors and trash pumps, plus HEPA vacuums, moisture meters, air sampling gear and jobsite power. Compare units by CFM, pints per day at AHAM and amp draw.

Choosing air scrubbers, dehumidifiers, air movers

Air scrubber size (CFM)

Work out CFM from room volume. Multiply the cubic feet by the air changes per hour in the job specification, then divide by 60. The ASD SHEPARD moves up to 400 CFM. The Phoenix Guardian R runs 250 to 500 CFM, and the Dri-Eaz HEPA 700 runs 275 to 700 CFM. The Novatek Novair 2000 runs at 1,000 or 2,000 CFM. Compare Air Scrubbers & Negative Air Machines.

LGR or desiccant dehumidifier

Low grain refrigerant (LGR) units are the usual commercial dehumidifier for water damage drying. Compare LGR dehumidifiers by pints per day at AHAM conditions (80°F, 60% RH), not the saturation figure. The INLINE Force One LGR 85 is listed at 85 pints at AHAM and up to 154 at saturation. The Dri-Eaz DriTec 4000i desiccant dehumidifier is made for cold or low-humidity spaces where refrigerant units slow down.

Air mover style

Low profile air movers fit tight spots such as under cabinets. The Phoenix AirMAX Radial moves 925 CFM. The INLINE Force One Centrifugal runs flat, at 45 degrees or upright to dry carpets, subfloors and walls. The Dri-Eaz Stealth AV3000 axial fan pushes long-throw air across open spaces. The XPower X-47ATR moves 3,600 CFM. See Low Profile Air Movers and Axial & Centrifugal Air Movers.

Amp draw and jobsite power

Add up amp draw before you plug in. Makers list the Phoenix AirMAX at up to six units on one 15-amp circuit. ASD Turtle kits run from a stove, dryer, range or generator outlet. They supply up to 60 amps of 120V power through four GFCI outlets, each with a 15-amp breaker and amp meter. See Power Distribution & GFCI.

Filters and pre-filters

Most air scrubbers put a primary pre-filter ahead of the HEPA filter. Some machines also take a secondary ring panel between them. Change pre-filters as they load to extend HEPA life. Wood HEPA filters come in face sizes such as 12 x 12 and 24 x 24 in, each 11-1/2 in deep. Match both to your machine. Makers offer carbon filters for odor and smoke jobs. Shop Air Scrubber Filters.

What is an air scrubber, and what does it do?

An air scrubber is a portable fan unit that pulls air through a pre-filter and a HEPA filter, then blows it back out. Abatement, remediation, restoration and construction crews use them to control airborne dust and particles. Many, such as the Phoenix Guardian R, can also be ducted to run as negative air machines.

Does an air scrubber remove mold?

An air scrubber does not remove mold growing on materials, but it filters airborne particles, which can include mold spores. Removing mold follows the remediation plan and job specification. Product notes for the Dri-Eaz F321 HEPA 500 filter advise replacing it after each mold or sewage job. They advise the same after use where asbestos may be present.

What is the difference between an LGR and a desiccant dehumidifier?

An LGR dehumidifier condenses water on cold refrigerant coils, while a desiccant dehumidifier pulls water vapor into a drying material. That lets a desiccant unit keep working in cold or very dry air. LGR units keep pulling water at lower humidity than standard refrigerant units.

What equipment do I need for water damage restoration?

Water damage restoration equipment usually means a water extractor or trash pump, air movers, a commercial dehumidifier and a moisture meter. Start with Flood & Water Extractors and Moisture Meters. Crews add an air scrubber when the job raises dust or involves mold.

What is a HEPA vacuum?

A HEPA vacuum is built so that all of its exhaust air passes through a HEPA filter before it leaves the machine. Crews use them for cleanup on abatement, mold and construction jobs. Dry units such as the Pullman-Holt 102 Series 967792201 (12 gallon, 110 CFM) are for dust. Wet/dry units such as the Husqvarna S11 (6.6 gallon, 157 CFM) also handle wet material. See HEPA Vacuums.